Cisco Cisco 3600 Series 8-Port Asynchronous Synchronous Serial NM Troubleshooting Guide
maui−soho−01(config)#interface Serial 2/0
maui−soho−01(config−if)#physical−layer async
!−−− Places the interface in asynchronous mode.
!−−− Continue to configure this Serial interface as you would configure
!−−− an Async Interface.
maui−soho−01(config−if)#ip add 10.0.0.1 255.255.255.0
maui−soho−01(config−if)#async mode interactive
maui−soho−01(config−if)#async default routing
maui−soho−01(config−if)#dialer in−band
maui−soho−01(config−if)#dialer map ip 10.0.0.2 name maui−nas−01 broadcast 5551111
!−−− These commands are part of a broader DDR configuration.
To connect a modem to this interface, refer to Configuring Dialout using a Modem on the AUX Port. This
document uses the AUX port. However, the configuration is very similar.
document uses the AUX port. However, the configuration is very similar.
To map the interface number to a line number, first multiply the slot number by 32, then add the unit number,
and add 1: line number = (<slot> * 32) + <unit> + 1.
and add 1: line number = (<slot> * 32) + <unit> + 1.
Use the command physical−layer sync or no physical−layer async to revert to the default sync mode. To
configure the interface for normal serial operation, refer to Configuring Serial Interfaces.
configure the interface for normal serial operation, refer to Configuring Serial Interfaces.
Related Information
Configuring Serial Interfaces
•
Configuring Dialout using a Modem on the AUX Port
•
Universal Gateways and Access Servers Product Support
•
Dial − Access: Technology Support Page
•
Technical Support and Documentation − Cisco Systems
•
Contacts & Feedback | Help | Site Map
© 2014 − 2015 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.
© 2014 − 2015 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.
Updated: Jan 29, 2008
Document ID: 7260