Cisco Cisco SM-X Layer 2 3 EtherSwitch Service Module

 below displays the internal port mapping for the Cisco SM-X Layer 2/3 ESM for the Cisco 

ISR G2. The variable “x” indicates the slot number where the Cisco SM-X-ES3-24-P, Cisco SM-X- 
ES3-16-P, and the SM-X-ES3D-48-P SKUs of the module are inserted on Cisco 3945 ISR G2. 

This section contains the following procedures:

 (required)

 (optional)

Before you can access the Cisco SM-X Layer 2/3 ESM CLI, you must connect to the host router through 
the router console or through Telnet. Once you are connected to the router, you must configure an IP 
address on the Gigabit Ethernet interface connected to the Cisco SM-X Layer 2/3 ESM. Open a session 
to the Cisco SM-X Layer 2/3 ESM using the service-module gigabitethernet x/0 session command in 
privileged EXEC mode on the router. 

You can use one of these methods to establish a connection to the Cisco SM-X Layer 2/3 ESM:

Gig x/0

Gig x/1

Gig x/0

Gig x/1

Cisco 3945

ISR- Host

SM-X-ES3D-48-P

SM-X-ES3-24-P

Cisco 3945

ISR- Host

Gig x/0

Gig x/1

SM-X-ES3-16-P

Cisco 3945

ISR- Host

361381

Gig 0/26

Gig 0/25

Gig 0/52

Gig 0/51

Gig 0/18

Gig 0/17

G0/1

G0/24

G0/1

G0/16

G0/1

G0/50

. . . . . . 

. . . . . . 

. . . . . . 

Front Panel Ports