Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP Release Notes
24
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
464831-006
Resolved Caveats
•
CSCsd85770
This error message no longer appears when you apply the mls qos trust dscp global configuration
command to a port:
command to a port:
Master sets trust failed, sets to untrust modetrust type update
failed on ifc GigabitEthernetx/x
Switch(config-if)#Tcam write failed trust dscp
%QOSMGR-4-COMMAND_FAILURE: Execution of slave:HQM_IDBTRUST_CMD
command failed on GigabitEthernetx/x
•
CSCse14774
When a switch is connected to a third-party router through an EtherChannel and the EtherChannel
is running in Link Aggregation Control Protocol (LACP) mode, the interfaces in the EtherChannel
no longer fail after you enter the switchport trunk native vlan vlan-id interface configuration
command to change the native VLAN from VLAN 1 (the default) to a different VLAN ID.
is running in Link Aggregation Control Protocol (LACP) mode, the interfaces in the EtherChannel
no longer fail after you enter the switchport trunk native vlan vlan-id interface configuration
command to change the native VLAN from VLAN 1 (the default) to a different VLAN ID.
•
CSCsg21537
When MAC addresses are learned on an EtherChannel port, the addresses are now correctly deleted
from the MAC address table.
from the MAC address table.
•
CSCsg30295
When you configure an IP address on a switch virtual interface (SVI) with DCHP and enable DHCP
snooping on the SVI VLAN, the switch SVI can now obtain an IP address.
snooping on the SVI VLAN, the switch SVI can now obtain an IP address.
•
CSCsg70630
A switch with the Dynamic ARP Inspection feature enabled no longer experiences the issue that
triggered the display of buffer sharecount messages under certain patterns of ARP packet traffic.
triggered the display of buffer sharecount messages under certain patterns of ARP packet traffic.
•
CSCsh74395
When a VLAN includes multiple MAC addresses, the number of MAC addresses shown in SNMP
now matches the output of the show mac-address count vlan vlan-id privileged EXEC command.
now matches the output of the show mac-address count vlan vlan-id privileged EXEC command.
•
CSCsi08513
MAC flap-notification no longer occurs when a switch is running VLAN bridge spanning-tree
protocol (STP) and fallback bridging is configured on the VLANs running STP.
protocol (STP) and fallback bridging is configured on the VLANs running STP.
•
CSCsi10584
Multiple Spanning-Tree Protocol (MSTP) convergence time has been improved for Cisco IOS
Release 12.2.
Release 12.2.
•
CSCsi63999
Changing the spanning tree mode from MSTP to other spanning modes no longer causes tracebacks.
•
CSCsi77705
Broadcast storm control now works correctly on IEEE 802.1Q trunk ports.
•
CSCsi78737
The cpmCPURising Threshold traps on the switch are no longer missing the
cpmProcExtUtil5SecRev and cpmProcessTimeCreated trap components. Note that although the
components were missing from the traps, the PROCESS MIB was still populating the objects.
cpmProcExtUtil5SecRev and cpmProcessTimeCreated trap components. Note that although the
components were missing from the traps, the PROCESS MIB was still populating the objects.
•
CSCsj22994
ACLs are now configured correctly when they contain ICMP codes 251 to 255.