Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP Release Notes

Page of 30
 
25
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
464831-006
Resolved Caveats
CSCsj47067
If you upgrade from Cisco IOS Release 12.2(35)SE1 to Release 12.2(37)SE, a security violation no 
longer occurs when:
You enter the switchport port-security maximum 1 vlan access interface configuration 
command. 
An IP phone with a PC behind it is connected to an access port with port security.
CSCsj52956 
The TxBufferFullDropCount counter no longer increments when the switch is a standalone switch.
CSCsj53001
The Total- output-drops field in the show interfaces privileged EXEC command output now 
displays accurate ASIC drops.
CSCsj64882 
When IGMP snooping is enabled, CGMP interoperability mode now works as it should when the 
upstream multicast router is set up correctly with PIM and IP CGMP. 
CSCsj77933
If you enter a space before a comma in the define interface-range or the interface range global 
configuration command, the space before the comma is now saved in the switch configuration. 
CSCsj87991
A switch configured for Link Layer Discovery Protocol (LLDP) now correctly reports the enabled 
switch capabilities in the LLDP type, length, and value (TLV) attributes. 
CSCsj90406
When VTP pruning is enabled, the switch no longer might experience high CPU usage (greater than 
90 percent) for up to 20 minutes after the link comes up simultaneously on multiple trunk ports. 
CSCsk25175
When the switch has VTP pruning and an RSPAN session configured, the RSPAN VLAN traffic is 
now correctly pruned as set up by the VTP pruning configuration.
CSCsk38083
When UDLD is enabled on a Layer 2 interface, and the native VLAN for the port is not configured 
as a VLAN on the switch, UDLD no longer puts the port into an error-disabled state.
CSCsk67520
If you enter the hostname global configuration command followed by a hostname that contains 
illegal characters, for example, one that appears to be an IP address, the switch now displays a 
warning message, but the specified hostname is configured. 
CSCsi85257
A Cisco IP Phone now works correctly when it is connected to a port that is configured with CDP 
bypass and multidomain authentication (MDA). 
CSCsk62010 
A switch no longer fails when you enter the show interfaces vlan vlan-id switchport privileged 
EXEC command.
CSCsl33304
Web authentication no longer stops working when IEEE 802.1X re-authentication is enabled and the 
re-authentication timer expires.