Cisco Cisco Unified IP Interactive Voice Response (IVR) 8.0(1) Installation Guide
Chapter 6 Performing the Initial Setup of Cisco CRS
Accessing Cisco CRS Administration
6-2
Cisco Customer Response Solutions Installation Guide, Release 6.0(1)
Accessing Cisco CRS Administration
You must access the Cisco CRS Administration web interface through its
Authentication page to perform the cluster setup or a server setup procedure.
Authentication page to perform the cluster setup or a server setup procedure.
After you complete the installation of Cisco CRS 6.0, the Cisco CRS
Administration Authentication page appears on the server on which you installed
when the server reboots. You can then take either of these actions to access
Cisco CRS Administration:
Administration Authentication page appears on the server on which you installed
when the server reboots. You can then take either of these actions to access
Cisco CRS Administration:
•
Log in to Cisco CRS Administration from the Authentication page
•
Exit the Authentication page, then access it and log in later from this server
or from another server
or from another server
To log in to Cisco CRS Administration, perform the following steps. If you want
to bookmark the Authentication page, complete the following procedure before
you do so.
to bookmark the Authentication page, complete the following procedure before
you do so.
Procedure
Step 1
If you exited the Authentication page when it appeared after you installed
Cisco CRS and the server rebooted, take one of these actions:
Cisco CRS and the server rebooted, take one of these actions:
•
On any server in the cluster and on which you have installed Cisco CRS,
choose Start > Programs > Cisco CRS Administrator> Application
Administration.
choose Start > Programs > Cisco CRS Administrator> Application
Administration.
•
From any computer in the network that meets the requirements described in
the
the
, enter the following
URL in a web browser, where servername is the host name or the IP address
of the server on which you installed Cisco CRS:
of the server on which you installed Cisco CRS:
http://servername/AppAdmin
If you use this method to access a server for which to perform the server setup
procedure, enter the IP address of that server.
procedure, enter the IP address of that server.
The Authentication page appears.