Cisco Cisco CRS Line Card Chassis Enhanced Installation Guide
Step 6
You need a ladder or step platform to remove the four top cover bolts as shown in the following figure. Use the 3/8-in.
ratchet wrench with 11/16-in. socket to loosen the four bolts holding the top wood and frame cushion system from the top
of the shipping box. Once the four bolts are loosened, remove each bolt manually and place aside, then remove the top
wood and frame cushion system from the chassis.
ratchet wrench with 11/16-in. socket to loosen the four bolts holding the top wood and frame cushion system from the top
of the shipping box. Once the four bolts are loosened, remove each bolt manually and place aside, then remove the top
wood and frame cushion system from the chassis.
Figure 10: Remove Four Top Cover Bolts From Chassis Shipping Box
Do not remove the chassis bag until you are ready to move and install the chassis.
Note
Step 7
When you are ready to remove the chassis bag, unseal the tape that exists around the perimeter of the chassis base and
pull the bag off the chassis.
pull the bag off the chassis.
What to Do Next
After performing this task, see the next section.
Attaching the Dolly to the Chassis and Removing the Chassis Pallet
This section describes how to attach the dolly to the Cisco CRS Series 16-Slot Line Card Chassis Enhanced router to remove the
chassis shipping pallet and prepare to move the chassis into place Only the 90-degree dolly configuration is used to remove the chassis
from the pallet.
chassis shipping pallet and prepare to move the chassis into place Only the 90-degree dolly configuration is used to remove the chassis
from the pallet.
21