Cisco Cisco CRS Line Card Chassis Enhanced Installation Guide
• 17-mm socket
• 3/4-inch socket
• 3/8-in. ratchet wrench with 6-in. extension
• 12-mm hex bit (included in the dolly packaging)
• Dolly (Cisco product number CRS-16-LIFT/B=)
Steps
To attach the dolly to the chassis, follow these steps:
Procedure
Step 1
Using a #1 Phillips screwdriver, remove the M5 x 10mm long button-head screws from the floor mount corner covers at
the base of chassis to expose the lift bracket holes. The following figure shows a section of the chassis with the corner
covers being removed and exposing the lift bracket holes (Follow the same procedure for both corner covers.) Put the two
floor mount corner covers aside until they are ready to be reinstalled. See Step 9 in
the base of chassis to expose the lift bracket holes. The following figure shows a section of the chassis with the corner
covers being removed and exposing the lift bracket holes (Follow the same procedure for both corner covers.) Put the two
floor mount corner covers aside until they are ready to be reinstalled. See Step 9 in
page 42
section for details on reinstalling the floor mount corner covers at the base of chassis.
23