Manualsbrain.com
  1. Manuals
  2. Brands
  3. Cisco
  4. Cisco DX70
  5. Technical References

Cisco Cisco DX70 Technical References

Download
Page of 173
D15363.02
 Cisco TelePresence DX70 and DX80 API Reference Guide CE8.2, SEPTEMBER 2016. 
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 
63
Cisco TelePresence DX70 and DX80
API Reference Guide
xConfiguration NetworkServices NTP Server [1..3] Address
The address of the NTP server that will be used when NetworkServices NTP Mode is set to 
Manual, and when NetworkServices NTP Mode is set to Auto and no address is supplied by a 
DHCP server.
Requires user role: ADMIN
Default value: 0.tandberg.pool.ntp.org
USAGE:
xConfiguration NetworkServices NTP Server 
n
 Address: "
Address
"
where
n
: Unique ID that identifies the NTP server. Range: 1..3
Address
: String (0, 255)
A valid IPv4 address, IPv6 address or DNS name.
xConfiguration NetworkServices SIP Mode
Define whether the system should be able to place and receive SIP calls or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration NetworkServices SIP Mode: 
Mode
where
Mode
: Off/On
Off: Disable the possibility to place and receive SIP calls.
On: Enable the possibility to place and receive SIP calls (default).
xConfiguration NetworkServices SNMP Mode
SNMP (Simple Network Management Protocol) is used in network management systems to 
monitor network-attached devices (routers, servers, switches, projectors, etc) for conditions 
that warrant administrative attention. SNMP exposes management data in the form of variables 
on the managed systems, which describe the system configuration. These variables can then 
be queried (set to ReadOnly) and sometimes set (set to ReadWrite) by managing applications.
Requires user role: ADMIN
Default value: ReadOnly
USAGE:
xConfiguration NetworkServices SNMP Mode: 
Mode
where
Mode
: Off/ReadOnly/ReadWrite
Off: Disable the SNMP network service.
ReadOnly: Enable the SNMP network service for queries only.
ReadWrite: Enable the SNMP network service for both queries and commands.
xConfiguration NetworkServices SNMP Host [1..3] Address
Define the address of up to three SNMP Managers.
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC 
program etc.), for example about system location and system contact. SNMP traps are not 
supported.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration NetworkServices SNMP Host 
n
 Address: "
Address
"
where
n
: Identifies the SNMP host. Maximum three SNMP hosts are allowed. Range: 1..3
Address
: String (0, 255)
A valid IPv4 address, IPv6 address or DNS name.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xConfiguration