Cisco Cisco 3365 Mobility Services Engine Release Notes

5 files

4 zips

database_installer_part1of4.zip

database_installer_part20f4.zip

database_installer_part3of4.zip

database_installer_part4of4.zip

1 Cisco-MSE-L-K9-7-3-101-0-64bit.bin.gz

To decompress (unzip) the file, execute: gunzip CISCO-MSE-L-K9-7-3-101-0-0-64bit.bin.gz.

Enter the following command: 

Stop the MSE service using the following command:

Uninstall the existing MSE software. Choose deletion of database when prompted.

Invoke the MSE installer. 

Doing so installs the new database using the four .zip files for the database along with the MSE software.

Initial database installation can take a long time (20 minutes at least -or- approximately). Do not cancel 
the installer midway through the installation process.

Once installed, follow the regular procedure to start, stop, or add an MSE to the Prime Infrastructure.

To upgrade the MSE to 7.3.101.0 from older releases with data migration, follow these steps:

Back up the existing database using the Prime Infrastructure. (We recommended this).

All data existing on the system will be lost and a fresh blank database will be created. 

Transfer the *.tar file for 7.3.101.0 to the MSE appliance:

Place all of the files in the /opt/installers folder.

Use binary mode when using FTP. Make sure that the downloaded file sizes are same as those 
on Cisco.com.

The *.tar file cannot be downloaded using the Prime Infrastructure download software interface. 
It should be manually transferred.

Do not uninstall the existing MSE software on the appliance. In other words, if you have 5.0, 
6.0, or 7.0 installed with data that you want to preserve across the upgrade to 7.3.101.0, do not 
uninstall it.