Cisco Cisco 3365 Mobility Services Engine Release Notes

Release Notes for Cisco 3300 Series Mobility Services Engine, Release 7.3.101.0

OL-24938-06

Upgrading the MSE

Data migration successfully completed. Will now proceed with installation of new image.

Installing...

----------------------

-------------------------------------------------

Database Installation

-----------------------

The installer will now install the database. This may take a long time (- 15 minutes).

Do not cancel the installer.

PRESS <ENTER> TO CONTINUE:

---------------------------------------------------

!!!!!! IMPORTANT NOTE !!!! :

---------------------------------

The system is minimally configured right now. It is strongly recommended that you run the

setup script under /opt/mse/setup/setup.sh to configure all appliance related parameters

immediately after installation is complete. The hostname must be set correctly on the

system. The Cisco MSE platform will NOT start if it is configured incorrectly or not

configured at all. Additionally, it is strongly recommended that the Cisco MSE is

configured to use the same NTP servers as the controllers with which it will be

synchronized. This is essential to the correct operation of the Cisco Mobility Services

Engine. Both these parameters may be configured as part of the setup script.

PRESS <ENTER> TO CONTINUE:

-------------------------------------------------

Importing Data

-------------------------------------------------

Loading data into newly installed database. This may take a while ......

PRESS <ENTER> TO CONTINUE:

Upgrading the MSE to 7.3.101.0 from 7.0.201.204 or Later Releases

To upgrade the MSE to 7.3.101.0 from 7.0.201.204 or later releases, follow these steps:

Note

Complete database installation is not required for upgrading from 7.0.101.204 or later releases.