Cisco Cisco NAC Appliance 4.1.0
Cisco NAC Appliance - Clean Access Manager Installation and Administration Guide
OL-12214-01
Chapter 3 Device Management: Adding Clean Access Servers, Adding Filters
Working with Clean Access Servers
Note
NAT Gateway (in-band or out-of-band) is not supported for production deployment.
The CAM can control both in-band and out-of-band Clean Access Servers in its domain. However,
the CAS itself must be either in-band or out-of-band.
the CAS itself must be either in-band or out-of-band.
For more information on out-of-band deployment, see
See the Cisco NAC Appliance - Clean Access Server Installation and Administration Guide for
further details on the CAS operating modes and NAT session throttling for NAT gateways.
further details on the CAS operating modes and NAT session throttling for NAT gateways.
7.
Click Add Clean Access Server. The Clean Access Manager looks for the Clean Access Server on
the network, and adds it to its list of managed Servers (
the network, and adds it to its list of managed Servers (
).
The Clean Access Server is now in the Clean Access Manager’s administrative domain.
Troubleshooting when Adding the Clean Access Server
See the Cisco NAC Appliance - Clean Access Server Installation and Administration Guide for
troubleshooting details.
troubleshooting details.
Manage the Clean Access Server
After adding the Clean Access Server, you can configure CAS-specific settings such as VLAN Mapping
or DHCP configuration. For some parameters, such as traffic control policies, the settings in the CAS
can override the CAM’s global settings.
or DHCP configuration. For some parameters, such as traffic control policies, the settings in the CAS
can override the CAM’s global settings.
Once you add the CAS to the Clean Access Manager, the CAS appears in the List of Servers tab as one
of the managed Servers, as shown in
of the managed Servers, as shown in
Figure 3-2
List of Servers Tab
Each Clean Access Server entry lists the IP address, server type, location, and connection status of the
CAS. In addition four management control icons are displayed: Manage (
CAS. In addition four management control icons are displayed: Manage (
), Disconnect (
), Reboot
(
), and Delete (
).
Click the Manage icon to administer the Clean Access Server.
Note
For further specifics on configuring Clean Access Servers (such as DHCP or high availability) see the
Cisco NAC Appliance - Clean Access Server Installation and Administration Guide.
Cisco NAC Appliance - Clean Access Server Installation and Administration Guide.