Cisco Cisco NAC Appliance 4.1.0
5-9
Cisco NAC Appliance - Clean Access Server Installation and Administration Guide
OL-12213-01
Chapter 5 Clean Access Server Managed Domain
Configure Network Settings for the CAS
Configure Network Settings for the CAS
This section describes the following:
•
•
•
IP Form
The IP form in the Network tab (
) contains the network settings of the CAS configured at
initial installation (or using the service perfigo config utility), as well as the CAS operating mode
chosen when the CAS was added to the CAM. You must use the IP form to configure the CAS for L3 or
L2 strict deployment, and you can use this form to view or change the IP address and network settings
of the CAS as described below.
chosen when the CAS was added to the CAM. You must use the IP form to configure the CAS for L3 or
L2 strict deployment, and you can use this form to view or change the IP address and network settings
of the CAS as described below.
1.
Access the IP form by navigating in the web console to Device Management > CCA Servers > List
of Servers > Manage [CAS_IP] > Network > IP.
of Servers > Manage [CAS_IP] > Network > IP.
Figure 5-4
CAS Network IP Settings
2.
The CAS IP form includes the following settings:
•
Clean Access Server Type —This is the operating mode of the CAS, set when you
. See
for additional details.
–
In-Band: Virtual Gateway, Real-IP Gateway, or NAT Gateway
–
OOB: Out-of-Band Virtual Gateway, Out-of-Band Real-IP Gateway, Out-of-Band NAT
Gateway
Gateway
Note
NAT Gateway (in-band or out-of-band) is not supported for production deployment.