Cisco Cisco Catalyst 4506-E Switch Installation Guide

All Catalyst 4500 E-series switches support hot swapping, which lets you install, remove, replace, and 
rearrange supervisor engines and switching modules without powering the system off. When the system 
detects that a switching module has been installed or removed, it runs diagnostic and discovery routines 
automatically, acknowledges the presence or absence of the module, and resumes system operation with 
no operator intervention.

This section contains the following subsections:

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 
Statement 1030

Ultimate disposal of this product should be handled according to all national laws and regulations. 
Statement 1040

You will need the following tools to install a supervisor engine in a Catalyst 4500 series switch:

Number 2 Phillips-head screwdrivers for the captive installation screws

3/16-in. flat-blade screwdriver for the captive installation screws on other modules

Antistatic mat or antistatic bag

ESD wrist strap or other grounding device

Link

Indicates the status of the 10/100/1000 BASE-T Ethernet 
management port or uplink ports.

Green

Orange

Flashing orange

Off

Active

Indicates whether the uplink port is active.

Green

The port is active.

Off

The port is not active.