Cisco Cisco Aironet 1400 Wireless Bridge Installation Guide

Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions

OL-7618-01

Assembling the Mounting Hardware

Assembling the Rooftop Mount

The optional rooftop or wall mount is used to mount your bridge to a flat horizontal or vertical surface,
such as a building wall or roof. You must assemble the rooftop mount before you can use it. To assemble
the mount, follow the instructions below:

Step 1

Place a washer on the long flanged hex bolt.

Step 2

Place the end of the mast pipe with the bolt holes into the mounting plate (see

Figure 2

Figure 2

Rooftop Support Bolt Locations

Step 3

Align the holes in the mast pipe with the holes in the mounting plate.

Step 4

Insert the long flanged hex bolt and washer into the upper holes on the mounting plate and through the
mast pipe (see

Figure 2

Step 5

Place a washer and hex nut on the end of the long flanged hex bolt and hand-tighten.

Step 6

Position the mast pipe and mounting plate as shown in

Figure 2

Step 7

Align the lower square hole in the mast pipe with the semi-circular cut-out on the mounting plate.

Step 8

Place the carriage bolt into the square hole on the inside of the mast pipe.

Step 9

Place a washer and hex nut on the end of the carriage bolt and hand-tighten.

Long flanged hex bolt

Carriage bolt

88949