Cisco Cisco Nexus 1010 Virtual Services Appliance Release Notes
3
Cisco Nexus Cloud Services Platform Release Notes, Release 5.2(1)SP1(7.2)
Upgrading from Cisco Nexus Cloud Services Platform Release 5.2(1)SP1(7.1) to 5.2(1)SP1(7.2)
Step 3
Enter the reload module module command to reload the standby supervisor module and allow it to come
back online:
back online:
switch# reload module ?
<1-2> Please enter the module number
•
If the primary module is the active module:
switch# reload module 2
This command will reboot standby supervisor module. (y/n)? [n] y
about to reset standby sup
2014 Oct 2 09:15:23 switch %PLATFORM-2-PFM_MODULE_RESET: Manual restart of Module 2
from Command Line Interface
2014 Oct 2 09:15:46 switch %PLATFORM-2-MOD_REMOVE: Module 2 removed (Serial number
T023D7CC381)
2014 Oct 2 09:22:50 switch %PLATFORM-2-MOD_DETECT: Module 2 detected (Serial number
:unavailable) Module-Type Cisco Virtual Services Appliance Model :unavailable
•
If the secondary module is the active module:
switch# reload module 1
This command will reboot standby supervisor module. (y/n)? [n] y
about to reset standby sup
switch# 2014 Oct 2 09:15:23 switch %PLATFORM-2-PFM_MODULE_RESET: Manual restart of
Module 1 from Command Line Interface
2014 Oct 2 09:15:46 switch %PLATFORM-2-MOD_REMOVE: Module 1 removed (Serial number
T023D7CC382)
Step 4
When the standby supervisor module is back online, verify the high availability (HA) synchronization
is complete with the active module:
is complete with the active module:
switch# show system redundancy status
Redundancy role
---------------
administrative: primary
operational: primary
Redundancy mode
---------------
administrative: HA
operational: HA
This supervisor (sup-1)
-----------------------
Redundancy state: Active
Supervisor state: Active
Internal state: Active with HA standby
Other supervisor (sup-2)
------------------------
Redundancy state: Standby
Supervisor state: HA standby
Internal state: HA standby
Step 5
After the HA synchronization is complete, switch over to the other module:
switch# system switchover
switch#
Broadcast message from root (console) (Thu Oct 2 09:28:33 2014):
The system is going down for reboot NOW!
Step 6
On the new active supervisor module, wait for the other supervisor module to come back online:
2014 Oct 2 09:28:33 switch %SYSMGR-2-HASWITCHOVER_PRE_START: This supervisor is becoming
active (pre-start phase).
2014 Oct 2 09:28:33 switch %SYSMGR-2-HASWITCHOVER_START: Supervisor 2 is becoming active.