Cisco Cisco ASR 5000
ALCAP Configuration Mode Commands
aal2-route ▀
Command Line Interface Reference, StarOS Release 18 ▄
1273
The default keyword can be used to configure a default aal2-route which will match any AESA received
from MSC and for which AESA specific route is not configured. When a connection is established an AESA
specific route will have higher priority than default route.
from MSC and for which AESA specific route is not configured. When a connection is established an AESA
specific route will have higher priority than default route.
Important:
The default route shall not be used when AESA specific route exists.
If an HNB-GW configured with a route for
MGW1
which consists of
AAL2_path_A
and
AAL2_path_B
for
AAL2 switch-A and AAL2 switch-B switch respectively then similarly AAL2 switch-A and AAL2 switch-
B need to be configured with routes for
B need to be configured with routes for
MGW1
.
A maximum of TBD AAL2 routes can be configured in one ALCAP service.
Example
Following command create a mapping between ATM endpoint
MGW1
and AAL2 node
aal2_1
for AAL2
connection routing purposes:
aal2-route end-point MGW1 aal2-node aal2_1