Cisco Cisco ASR 5000
APN Configuration Mode Commands
▀ accounting-mode
▄ Command Line Interface Reference, StarOS Release 18
1290
accounting-mode
Configures the protocol to be used for PDP context accounting by this APN.
Product
eWAG
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
In 16.0 and earlier releases:
accounting-mode { gtpp | none | radius-diameter [ no-early-pdus ] [ no-interims ] }
default accounting-mode
In 17.0 and later releases:
accounting-mode { gtpp | none | radius [ no-early-pdus ] [ no-interims ] }
default accounting-mode
default
Restores the command to its default setting.
gtpp
Configures the APN to use GPRS Tunneling Protocol Prime for accounting purposes. If used, accounting will
begin as soon as the PDP context is established. This is the default setting. Default: Enabled
begin as soon as the PDP context is established. This is the default setting. Default: Enabled
Important:
The system’s GTPP parameters must be configured prior to using this protocol for accounting. Refer
to the
gtpp
commands in the Context Configuration Mode Commands chapter.
In 16.0 and earlier releases, the default value of “
accounting-mode gtpp
” was not displayed in the “
show
configuration
” command. The value was only displayed in the output of “
show configuration
verbose
” command.
In 17.0 and later releases, even for a default configuration of
accounting-mode
under APN, this will be
indicated in “
show configuration
” both in verbose and non-verbose modes.