Cisco Cisco ASR 5000
BGP Address-Family (IPv4/IPv6) Configuration Mode Commands
▀ neighbor
▄ Command Line Interface Reference, StarOS Release 18
1636
remove-private-AS
Removes the private AS number from outbound updates. Default: Do not remove the private AS number.
restart-time
rest_time
Specifies the maximum time (in seconds) required to for neighbor to restart as an integer from 1 through
3600.
3600.
route-map
map_name
{
in
|
out
}
Applies a route map to the neighbor.
map_name
must be the name of an existing route-map in the current
context.
in
: Indicates that the route map applies to incoming advertisements.
out
: Indicates that the route map applies to outgoing advertisements.
send-community
{
both
|
extended
|
standard
}
Sends the community attributes to a peer router (neighbor).
both
:Sends standard and extended community attributes
extended
:Sends extended community attributes.
standard
:Sends standard community attributes.
shutdown
Administratively shuts down this neighbor. This disables exchanging routes or configuring parameters for
this neighbor.
this neighbor.
srp-activated-soft-clear
Enables BGP updates when SRP-enabled resources are modified.
timers
{ [
connect-interval
connect_interval
] | [
keepalive-interval
keepalive_interval
holdtime-interval
holdtime_interval
] }
Sets BGP timers for the specified neighbor.
connect-interval
connect_interval
: Specifies the connect timer (in seconds) as an integer from 0
through 65535. The default is 60 seconds.
keepalive-interval
keepalive_interval
: Specifies the frequency (in seconds) at which the current
BGP router sends keepalive messages to its neighbor.
keep_time
must be an integer from 0 through 65535.
The default is 30 seconds.
holdtime-interval
holdtime_interval
: Specifies the interval (in seconds) the router waits for a
keepalive message before declaring a neighbor dead.
hold_time
must be an integer from 0 through 65535.
The default is 90 seconds.
min-peer-holdtime-interval
min_peer_hold_interval
: Specifies the minimum acceptable hold
time (in seconds) from peer for a keepalive message before declaring a neighbor dead.
min_peer_hold_interval
must be an integer from 0 through 65535. The default is 90 seconds.
update-source
ip_address
Binds the specified IP address to the BGP socket that is used to communicate to the peer.
ip_address
is an
IPv4 address in dotted-decimal notation.
In most cases you should set the update-source address to the address of the loopback interface in the current
context. By doing this, the TCP connection does not go down until there is no route for the loopback address
in the peering router.
In most cases you should set the update-source address to the address of the loopback interface in the current
context. By doing this, the TCP connection does not go down until there is no route for the loopback address
in the peering router.