Cisco Cisco ASR 5000
Card Configuration Mode Commands
mode ▀
Command Line Interface Reference, StarOS Release 18 ▄
2175
Usage
Set the desired mode of mated cards. The card targeted for maintenance is placed in the standby state first.
The setting of the mode determines which packet processing cards are to be active and which are to be the
standby cards for redundancy. Use this command to configure the set of active and standby packet processing
cards. The application processor card’s standby priority is then used in conjunction with the set of standby
packet processing cards to determine the order in which the standby cards are used for redundancy support.
The setting of the mode determines which packet processing cards are to be active and which are to be the
standby cards for redundancy. Use this command to configure the set of active and standby packet processing
cards. The application processor card’s standby priority is then used in conjunction with the set of standby
packet processing cards to determine the order in which the standby cards are used for redundancy support.
Important:
Not supported on all platforms
Important:
This command results in a migration of processes if the mode specified for the card is different than
the current state of the card.
Example
The following commands set the state of a card to active and standby, respectively.
mode active
mode standby