Cisco Cisco ASR 5000
Credit Control Configuration Mode Commands
▀ diameter peer-select
▄ Command Line Interface Reference, StarOS Release 18
2838
Specifies peer selection based on International Mobile Subscriber Identification (IMSI) range.
start-value imsi_start_value
specifies the start of range in integer value of IMSI, and
end-value
imsi_end_value
specifies the end of range in integer value of IMSI.
imsi-based { { prefix | suffix } imsi/prefix/suffix_start_value } [ to
imsi/prefix/suffix_end_value ]
imsi/prefix/suffix_end_value ]
Important:
This section applies only to 9.0 and later releases for UMTS deployments.
Selects peer based on IMSI prefix or suffix or IMSI range.
prefix
: Specifies the prefix range
suffix
: Specifies the suffix range
imsi/prefix/suffix_start_value
: Specifies the IMSI/prefix/suffix start value.
prefix/suffix
must
be an IMSI prefix/suffix, and must be an integer from 1 through 15 characters.
imsi/prefix/suffix_end_value
: Specifies the IMSI/prefix/suffix end value.
prefix/suffix
must be
an IMSI prefix/suffix, and must be an integer from 1 through 15 characters that must be greater than the start
value.
value.
Important:
If prefix/suffix is used, the lengths of both start and end prefix/suffix must be equal. If the
prefix
or
suffix
keyword is not specified, it will be considered as suffix.
msisdn-based { { prefix | suffix } msisdn/prefix/suffix_start_value } [ to
msisdn/prefix/suffix_end_value ]
msisdn/prefix/suffix_end_value ]
Specifies peer selection based on MSISDN prefix or suffix or MSISDN range.
prefix
: Specifies the prefix range
suffix
: Specifies the suffix range
msisdn/prefix/suffix_start_value
: Specifies the MSISDN/prefix/suffix start value.
prefix/suffix
must be an MSISDN prefix/suffix, and must be an integer from 1 through 15 characters.
msisdn/prefix/suffix_end_value
: Specifies the MSISDN/prefix/suffix end value.
prefix/suffix
must be an MSISDN prefix/suffix, and must be an integer from 1 through 15 characters that must be greater
than the start value.
than the start value.
realm realm_name
The
realm_name
must be an alphanumeric string of 1 through 127 characters, and can contain punctuation
characters. The realm may typically be a company or service name.
secondary-peer secondary_peer_name
Specifies a name for the secondary host to be used for failover processing. When the route-table does not find
an AVAILABLE route, the secondary host performs a failover processing if the
an AVAILABLE route, the secondary host performs a failover processing if the
command is set.
secondary_peer_name
must be an alphanumeric string of 1 through 63 characters, and can contain
punctuation characters.
Usage
Use this command to configure Diameter credit control host selection.