Cisco Cisco ASR 5000
CSCF Access Profile Configuration Mode Commands
▀ timeout
▄ Command Line Interface Reference, StarOS Release 18
3074
timer C in S-CSCF fires first, S-CSCF will send CANCEL request to Terminating P-CSCF and Terminating
P-CSCF will send CANCEL request to UAS.
P-CSCF will send CANCEL request to UAS.
sec
must be an integer from 180 to 2147483646.
Default: 180 seconds
d
sec
: This time is used to control the retransmission of 200 OK to INVITE after ACK is sent. The ACK
transaction will be cleared after this interval. This timer is applicable only for unreliable transport.
sec
must be an integer from 0 to 2147483646.
Default: 64*T1 (32 seconds, recommended minimum)
invite-expiry
sec
: This timer is used by SIP while acting as UA Role and no final response is received
for the INVITE request sent. This timer is applicable for both reliable and unreliable transport.
sec
must be an integer from 0 to 2147483646.
Default: 100 seconds (recommended minimum).
t1
msec
: Specifies the time interval (in milliseconds) between each retransmission. The interval doubles after
each retransmission, for example: T1, 2T1, 4T2, etc. This timer is applicable only for unreliable transport.
msec
must be an integer from 0 to 2147483646.
Default: 500 milliseconds (recommended minimum).
t2
sec
: This timer is used to control the period for which the request keeps getting retransmitted. This timer
is applicable both for reliable and unreliable transport.
sec
must be an integer from 0 to 2147483646. The recommended minimum value for this parameter is 4
seconds.
Default: 64*T1 (32 seconds)
Default: 64*T1 (32 seconds)
t4
sec
: This timer is used to control the period for which the final response to non-invite transaction should
be buffered so as to send the buffered response for the retransmitted non-invite request within that interval.
This timer is applicable only for unreliable transport.
This timer is applicable only for unreliable transport.
sec
must be an integer from 0 to 2147483646.
Default: 5 seconds (recommended minimum).
default
Sets/restores default value assigned for specified parameter.
Usage
Use this command to configure SIP Stack timers and CSCF service specific timers for subscriber traffic using
this Access Profile.
this Access Profile.
Example
The following command sets the SIP d timer to
64
seconds:
timeout sip d 64