Cisco Cisco ASR 5000
CSCF Serving-CSCF Configuration Mode Commands
authentication ▀
Command Line Interface Reference, StarOS Release 18 ▄
3367
sends 500 error response to UE. When
allow-hss-failure
is enabled, S-CSCF sends 200 OK for register
instead of 500 response.
allow-noauth [ invite | re-register| register ]
Specifies that access to the S-CSCF service is allowed if authentication fails.
invite
: Specifies that access to the S-CSCF service is allowed if authentication fails on INVITE requests
only.
re-register
: Specifies that access to the S-CSCF service is allowed if authentication fails on RE-
REGISTER requests when the request is integrity-protected only.
registration
: Specifies that access to the S-CSCF service is allowed if authentication fails on REGISTER
requests only.
allow-noipauth [ invite | re-register| register ]
Specifies that access to the S-CSCF service is allowed if early IMS-based IP authentication fails.
invite
: Specifies that access to the S-CSCF service is allowed if early IMS-based IP authentication fails on
INVITE requests only.
re-register
: Specifies that access to the S-CSCF service is allowed if authentication fails on RE-
REGISTER requests when the request is integrity-protected only.
registration
: Specifies that access to the S-CSCF service is allowed if early IMS-based IP authentication
fails on REGISTER requests only.
allow-skip-sar re-register
Specifies that S-CSCF should skip SAR to HSS for re-register.
When S-CSCF receives re-register/challenge for re-register, it sends SAR to HSS to get subscriber profile. To
avoid overloading HSS, enabling
When S-CSCF receives re-register/challenge for re-register, it sends SAR to HSS to get subscriber profile. To
avoid overloading HSS, enabling
allow-skip-sar
allows S-CSCF to skip SAR for re-register.
allow-unsecure
Specifies that un-secure access is allowed to the S-CSCF service.
aor-auth
Specifies that authentication is based on the AoR when accessing the S-CSCF service.
custom-md5
value
Specifies that custom algorithm HTTP-Digest-MD5 is used as the authentication type for accessing the S-
CSCF service.
CSCF service.
value
specifies a preference - the lower the value, the higher the preference.
value
must be
an integer from 1 to 1000.
Important:
In order to change a priority level, you must remove the original value and configure a new one.
md5
value
Specifies that the MD5 algorithm is used as the authentication type for accessing the S-CSCF service.
value
specifies a preference - the lower the value, the higher the preference.
value
must be an integer from
1 to 1000.
Important:
In order to change a priority level, you must remove the original value and configure a new one.