Cisco Cisco ASR 5000
DHCP Service Configuration Mode Commands
dhcp server ▀
Command Line Interface Reference, StarOS Release 18 ▄
3489
port_num
is an integer from 0 through 65535.
Important:
While configuring HNB-GW for DHCP proxy support, operator must define 61610 as UDP port for
DHCP server. The source port used by HNBGW will be standard DHCP port, irrespective of the server port that is
configured.
configured.
priority priority
Specifies the priority of the server if multiple servers are configured.
priority
is an integer from 1 through 1000. 1 is the highest priority.
Important:
In the case of DeWAG, this option must not be configured.
Usage
Use this command to configure the DHCP server(s) that the system is to communicate with. Multiple servers
can be configured each with their own priority. Up to 20 DHCP servers can be configured.
All DHCP messages are sent/received on UDP port 67.
can be configured each with their own priority. Up to 20 DHCP servers can be configured.
All DHCP messages are sent/received on UDP port 67.
Important:
If a server is removed, all calls having an IP address allocated from the server will be released.
Example
The following command configures a DHCP server with an IP address of
192.168.1.200
and a priority of
1
:
dhcp server 192.168.1.200 priority 1