Cisco Cisco ASR 5000
eGTP Service Configuration Mode Commands
validation-mode ▀
Command Line Interface Reference, StarOS Release 18 ▄
3687
validation-mode
Configures the type of validation to be performed on messages received by this service.
Product
ePDG
P-GW
SAEGW
SGSN
Important:
The ePDG and SGSN are not currently supported on the ASR 5500 platform.
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > eGTP Service Configuration
configure > context context_name > egtp-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-egtp-service)#
Syntax
validation-mode { custom1 | standard }
default validation-mode
default
Returns the command to the default setting of
standard
.
{ custom1 | standard }
custom1
: Specifies that the message should be validated based on a vendor-specific set of mandatory
elements.
standard
: Specifies that the message should be validated based on the set of mandatory elements as defined
in 3GPP 29.274. This is the default option on an S4-SGSN.
Usage
Use this command to specify the type of validation performed on messages received by this service. The
information elements contained in messages have mandatory elements and conditional elements. The
standard set of elements, as defined by 3GPP 29.274 is checked if this command is set to “standard”. The
custom1 setting is for a vendor-specific set of mandatory elements.
information elements contained in messages have mandatory elements and conditional elements. The
standard set of elements, as defined by 3GPP 29.274 is checked if this command is set to “standard”. The
custom1 setting is for a vendor-specific set of mandatory elements.
Example
The following command sets the validation mode for incoming messages to
standard
:
validation-mode standard