Cisco Cisco ASR 5000
ACS Charging Action Configuration Mode Commands
flow action ▀
Command Line Interface Reference, StarOS Release 18 ▄
407
discard [ downlink | uplink ]
Specifies to discard the specified packets.
downlink
: Downlink packets
uplink
: Uplink packets
If
downlink
or
uplink
keyword is not specified, both downlink and uplink packets will be discarded.
random-drop interval interval_start to interval_end pkts-to-drop packet_min to
packet_max
packet_max
Specifies to drop a group of consecutive packets (
pkts-to-drop
) to be dropped in the specified time
interval (
random-drop interval
). This will cause degradation in user experience. P2P VoIP would need
more than one packet to be dropped, since that type of protocol is geared to handle occasional single packet
drops.
drops.
random-drop interval interval_start to interval_end
: Specifies the random drop
interval, in seconds, at which the voice packets will be dropped.
interval_start
and
interval_end
must be integers from 1 through 999.
pkts-to-drop packet_min to packet_max
: Specifies the number of voice packets to be dropped
at a time in a flow when the packets have to be dropped.
packet_min
and
packet_max
must be integers from 1 through 100.
readdress [ [ server ipv4_address/ipv6_address [ discard-on-failure ] [ dns-
proxy-bypass ] ] [ port port_number [ discard-on-failure ] [ dns-proxy-bypass ] ]
| server-list server_list_name [ hierarchy ][ round-robin ] [ discard-on-failure
] [ dns-proxy-bypass ] ]
proxy-bypass ] ] [ port port_number [ discard-on-failure ] [ dns-proxy-bypass ] ]
| server-list server_list_name [ hierarchy ][ round-robin ] [ discard-on-failure
] [ dns-proxy-bypass ] ]
Specifies to readdress the location of the uplink packets for charging action.
server ipv4_address/Ipv6
: Specifies the re-address server’s IPv4/IPv6 address.
port port_number
: Specifies the re-address server’s port number.
port_number
must be an integer from 1 through 65535.
Important:
You can optionally keep the original destination address and just
change the destination TCP/UDP port number.
server-list server_list_name
Important:
This option is available only in StarOS 14.1 and later releases. This
keyword is license dependent. For more information please contact your Cisco account
representative.
representative.
Specifies to readdress the packet flow to the DNS servers configured under the server list.
For more information about configuring the server list, see the ACS Readdress Server List
Configuration Mode chapter.
Configuration Mode chapter.
hierarchy
Specifies the hierarchy approach to select the server list from the readdress server list.
round-robin