Cisco Cisco ASR 5000
Exec Mode Commands (T-Z)
▀ update active-charging
▄ Command Line Interface Reference, StarOS Release 18
4264
update active-charging
Updates specified active charging option(s) for the matching sessions.
Product
ACS
PSF
NAT
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
update active-charging { override-control rulebase-config | switch-to-fw-and-nat-policy
fw_nat_policy_name | switch-to-rulebase rulebase_name } { all | callid call_id | fw-and-
nat-policy fw_nat_policy_name | imsi imsi | ip-address ip_address | msid msid | rulebase
rulebase_name | username user_name } [ -noconfirm ] [ | { grep grep_options | more } ]
fw_nat_policy_name | switch-to-rulebase rulebase_name } { all | callid call_id | fw-and-
nat-policy fw_nat_policy_name | imsi imsi | ip-address ip_address | msid msid | rulebase
rulebase_name | username user_name } [ -noconfirm ] [ | { grep grep_options | more } ]
override-control rulebase-config
This keyword initiates batch processing of all active calls to apply Override Control (OC) or Inheritance after
any rulebase changes, charging action changes and/or addition/deletion of ruledefs for all subscribers having
OC or Inheritance feature enabled. Since this is the batch processing of all active calls, the command
execution will be in the background even after the CLI command returns to the CLI prompt.
any rulebase changes, charging action changes and/or addition/deletion of ruledefs for all subscribers having
OC or Inheritance feature enabled. Since this is the batch processing of all active calls, the command
execution will be in the background even after the CLI command returns to the CLI prompt.
Important:
Override Control is a license-controlled feature. A valid feature license must be installed prior to
configuring this feature. For more information on the licensing requirements, contact your Cisco account representative.
For more information on the command to enable this feature, refer to ACS Rulebase Configuration Mode Commands
chapter in the Command Line Interface Reference.
For more information on the command to enable this feature, refer to ACS Rulebase Configuration Mode Commands
chapter in the Command Line Interface Reference.
Important:
In this release, both Inheritance and the Override Control features are supported. Note that these two
features should not be enabled simultaneously. If by mistake, these two features are enabled, only Override Control is
applied.
applied.
In 17 and later releases, this CLI command is used to apply the overridden or inherited values after any
ruledef, charging action and rulebase changes performed through the CLI commands in the respective
configuration modes. This CLI command is necessary because the configuration changes are reflected
immediately on any new PDN session that gets established. However, for the existing PDN sessions
established before the configuration change, explicit execution of this CLI command is necessary. This will
get all the PDN sessions in system in sync with respect to the required configuration changes.
ruledef, charging action and rulebase changes performed through the CLI commands in the respective
configuration modes. This CLI command is necessary because the configuration changes are reflected
immediately on any new PDN session that gets established. However, for the existing PDN sessions
established before the configuration change, explicit execution of this CLI command is necessary. This will
get all the PDN sessions in system in sync with respect to the required configuration changes.