Cisco Cisco ASR 5000
Exec Mode show Commands (H-L)
show ip pool ▀
Command Line Interface Reference, StarOS Release 18 ▄
4687
hold-timer {imsi
imsi
| msid
msid
| username
username
[imsi
imsi
| msid
msid]}
Displays hold timer address information for the specified IMSI, MSID, or username.
imsi
imsi
: Displays hold-timer information for a valid IMSI (International Mobile Subscriber Identity),
specified as a 15-character field that identifies the subscriber’s home country and carrier.
msid
msid
: Displays hold-timer information for the MSID specified as a number from 7 through 16 digits.
username
username
: Displays hold-timer information for an existing username specified as an
alphanumeric string of 1 through 127 characters.
Important:
Active users cannot be displayed. If an active ID or username is entered, the following error message
appears: Failure: No address matching the specified information was found! Please confirm that the options used match
the network architecture/deployment,i.e. IMSI/MSID only, Username only, or IMSI/MSID plus Username. Please note
that this command does not apply for addresses in the used state.
the network architecture/deployment,i.e. IMSI/MSID only, Username only, or IMSI/MSID plus Username. Please note
that this command does not apply for addresses in the used state.
many-to-one
Lists information on Many-to-One NAT Realm IP address pools.
nat-realm
Lists information on NAT Realm IP address pools.
one-to-one
Lists information One-to-One NAT Realm IP address pools.
overlap
Lists information on overlapping IP pools.
pool-name
pool_name
Displays information about an existing IP pool.
private
Displays information about IP pools marked Private.
public
Displays information about IP pools marked Public.
resource
Displays information about resource IP pools.
static
Displays information about static IP pools.
summary
Displays a summary of all IP pool information.
verbose
Displays detailed information about all IP pools.