Cisco Cisco ASR 5000
ACS Configuration Mode Commands
▀ policy-control update-default-bearer
▄ Command Line Interface Reference, StarOS Release 18
562
policy-control update-default-bearer
For PCEF Bearer Binding in 4G, this command allows you to enable/disable binding rules having QoS of default bearer
to the default bearer and to not ignore/ignore other rules.
to the default bearer and to not ignore/ignore other rules.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
[ default | no ] policy-control update-default-bearer
default
Configures this command with its default setting.
Disables only binding those rules having QoS of default bearer to the default bearer and specifies to not
ignore other rules. Rules having respective QoS will get attached to the relevant bearers. Also TFT updates
towards UE (access side) will not be suppressed.
Disables only binding those rules having QoS of default bearer to the default bearer and specifies to not
ignore other rules. Rules having respective QoS will get attached to the relevant bearers. Also TFT updates
towards UE (access side) will not be suppressed.
no
Enables binding rules having QoS of default bearer to the default bearer and specifies to ignore other rules. In
case no QoS is specified the rule gets attached to default bearer. Also TFT updates towards UE (access side)
will be suppressed for default bearer. So only one default-bearer will ever be created.
case no QoS is specified the rule gets attached to default bearer. Also TFT updates towards UE (access side)
will be suppressed for default bearer. So only one default-bearer will ever be created.
Caution:
Upon executing this CLI command “
no policy-control update-default-bearer
”, system
crash is likely to occur if the TFT information is not added to the charging-action.
Usage
This CLI command is used to bind all the PCC dynamic or predef rules received from PCRF without QoS
and ARP or with the same QoS and ARP as that of the default bearer, to the default bearer.
On receiving a PCC dynamic rule or predef rule from PCRF, having QoS/ARP other than the default bearer,
then those rules are ignored and a response indicating that the rule could not be installed, is sent.
This CLI command will not work currently for dedicated bearers (secondary PDP contexts). Secondary
bearers initiated by UE are not supported.
Releases prior to 12.2 TFT updates were sent towards the UE (access side) on all bearers. Release 12.2
onwards, TFT updates will be suppressed towards the UE (access side) for default bearer, if the CLI is
enabled.
and ARP or with the same QoS and ARP as that of the default bearer, to the default bearer.
On receiving a PCC dynamic rule or predef rule from PCRF, having QoS/ARP other than the default bearer,
then those rules are ignored and a response indicating that the rule could not be installed, is sent.
This CLI command will not work currently for dedicated bearers (secondary PDP contexts). Secondary
bearers initiated by UE are not supported.
Releases prior to 12.2 TFT updates were sent towards the UE (access side) on all bearers. Release 12.2
onwards, TFT updates will be suppressed towards the UE (access side) for default bearer, if the CLI is
enabled.