Cisco Cisco ASR 5000
GTPC Load Control Profile Configuration Mode Commands
weightage ▀
Command Line Interface Reference, StarOS Release 18 ▄
6129
license-session-utilization percentage
Specifies the license session utilization as a percentage of 100.
percentage
must be an integer from 0 to 100.
Default: 30%
default weightage
Returns all parameters to their default settings.
Usage
Use this command to set weightage percentages for system CPU, memory, and license session utilization as
part of a GTP-C Load Control Profile configuration. These settings constitute the basic Load Control Profile
for this network element. These parameters allow the P-GW/S-GW/SAEGW to send its load information to a
peer GTP control plane node which the receiving GTP control plane peer node uses to augment existing GW
selection procedure for the P-GW and S-GW. Load Information reflects the operating status of the resources
of the originating GTP control plane node.
If no parameters are specified, the system will use the default settings.
Operators should also configure the
part of a GTP-C Load Control Profile configuration. These settings constitute the basic Load Control Profile
for this network element. These parameters allow the P-GW/S-GW/SAEGW to send its load information to a
peer GTP control plane node which the receiving GTP control plane peer node uses to augment existing GW
selection procedure for the P-GW and S-GW. Load Information reflects the operating status of the resources
of the originating GTP control plane node.
If no parameters are specified, the system will use the default settings.
Operators should also configure the
inclusion-frequency
command in GTP-C Load Control Profile
Configuration mode to specify parameters to determine the inclusion frequency of the Load Control
Information IE sent to peers for the GTP-C Load Control Profile configuration.
The Load Control Profile must be associated with a P-GW, S-GW, or SAEGW service using one of the
following commands:
Information IE sent to peers for the GTP-C Load Control Profile configuration.
The Load Control Profile must be associated with a P-GW, S-GW, or SAEGW service using one of the
following commands:
P-GW:
associate
command in P-GW Service Configuration Mode
S-GW:
associate
command in S-GW Service Configuration Mode
SAEGW:
associate
commands in both P-GW and S-GW Service Configuration modes
Example
The following example configures system-cpu-utilization at 30%, system-memory utilization at 40%, and
license-utilization at 30%.
license-utilization at 30%.
weightage system-cpu-utilization 30 system-memory-utilization 40 license-
session-utilization 30
session-utilization 30