Cisco Cisco ASR 5000
GTP-U Service Configuration Mode Commands
bind ▀
Command Line Interface Reference, StarOS Release 18 ▄
6213
ipv6_address
must be entered using IPv6 colon-separated-hexadecimal notation.
crypto-template crypto_template
Configures crypto template for IPSec, which enables IPSec tunneling for this GTP-U address. Must be
followed by the name of an existing crypto template.
followed by the name of an existing crypto template.
crypto_template
must be an alphanumeric string of 1 through 127 characters.
ike-bind-address ip_address
Configures an IKE bind address. Must be followed by IPv4 or IPv6 address; IP address type must be the same
as the GTP-U address type.
as the GTP-U address type.
ipv4_address
must be entered using IPv4 dotted-decimal notation.
ipv6_address
must be entered using IPv6 colon-separated-hexadecimal notation.
bearer-type non-ims-media | ims-media | all
Specifies the type of bearer to be associated with the bind address. Default behavior is for that the address
will be used for all bearer types.
will be used for all bearer types.
non-ims-media
configures bind address for non-ims media only.
ims-media
configures bind address for ims-media traffic only.
all
configures bind address to handle all types of bearer traffic. This is the default setting.
Usage
Use this command to bind the service to an interface for sending/receiving GTP-U packets.
Important:
A GTP-U service can support a maximum of 12 GTP-U endpoints/interfaces.
Example
The following command configures the IPv4 address for this GTP-U service as
10.2.3.4
:
bind ipv4-address 10.2.3.4