Cisco Cisco ASR 5000
OSPF VRF Configuration Mode Commands
▀ neighbor
▄ Command Line Interface Reference, StarOS Release 18
7612
neighbor
Configures OSPF routers that interconnect to non-broadcast networks.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > OSPF Configuration > OSPF VRF Configuration
configure > context context_name > router ospf > ip vrf vrf_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-ospf-vrf)#
Syntax
[ no ] neighbor ip_address [ poll-interval poll_interval_value ] [ priority
priority_value ]
priority_value ]
no
Disables OSPF routers that interconnect to non-broadcast networks.
ip_address
Specifies the interface IP address of the OSPF neighbor expressed using IPv4 dotted-decimal notation.
poll-interval
poll_interval_value
Default: 120
Sets the number of seconds in the dead neighbor polling interval as an integer from 1 through 65535
Sets the number of seconds in the dead neighbor polling interval as an integer from 1 through 65535
priority
priority_value
Default: 0
Sets the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the specified IP address. This must be an integer from 0 through 255. This keyword does not apply to point-
to-multipoint interfaces.
Sets the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the specified IP address. This must be an integer from 0 through 255. This keyword does not apply to point-
to-multipoint interfaces.
Usage
Use this command to configure OSPF routers that connect to non-broadcast networks.
Example
The following command specifies an OSPF router neighbor with the IP address of
192.168.100.10
:
neighbor 192.168.100.10