Cisco Cisco ASR 5000
SGSN Pool Area Configuration Mode Commands
hash-value ▀
Command Line Interface Reference, StarOS Release 18 ▄
8587
Usage
Use this command to command configures the load distribution for the VLRs that service this pool area as
defined in TS 23.236.
The algorithm for selection of VLR from a pool area is based on the hash value computed on the IMSI digits.
The SGSN derives a hash value (V) using procedure as defined in TS 23.236. Every hash value from the
range 0 to 999 corresponds to a single MSC/VLR node. Typically many hash values may point to the same
MSC/VLR node.
This command can be entered multiple times for different hash value.
defined in TS 23.236.
The algorithm for selection of VLR from a pool area is based on the hash value computed on the IMSI digits.
The SGSN derives a hash value (V) using procedure as defined in TS 23.236. Every hash value from the
range 0 to 999 corresponds to a single MSC/VLR node. Typically many hash values may point to the same
MSC/VLR node.
This command can be entered multiple times for different hash value.
Example
Following command configure the all non configured hash values to use VLR named
starvlr1
in this pool
area:
hash-value non-configured-values use-vlr starvlr1