Cisco Cisco ASR 5000

Page of 9109
  Subscriber Configuration Mode Commands 
ppp  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
8921 
Configures an IPv6-to-IPv4 (6to4) tunnel and controls the behavior of IPv6CP negotiation for the Interface 
ID. If enabled, PDSN will accept a valid interface-id proposed by the peer. 
data-compression { mode { normal | stateless } | protocols {
 
protocols
 
 [
 
protocols
 
] }
 
Default: all protocols enabled. 
Specifies the subscriber’s mode of data compression or the compression protocol to use. 
mode
: sets the mode of compression where 
modes
 must be one of: 
 
normal
: Packets are compressed using the packet history for automatic adjustment for best 
compression. 
 
stateless
: Each packet is compressed individually. 
protocols
 
protocols
: sets the compression protocol where 
protocols
 must be one of: 
 
deflate
: DEFLATE algorithm 
 
mppc
: Microsoft PPP algorithm 
 
stac
: STAC algorithm 
ip-header-compression negotiation { detect | force | vj compress-slot-id { both | 
none | receive | transmit } }
 
Default: 
force
 
detect
: The local side does not include the Van Jacobson (VJ) Compression option in its IPCP 
configuration request unless the peer sends an Internet Protocol Control Protocol (IPCP) NAK including a VJ 
compression option. If the peer requests the VJ compression option in its IPCP request the local side will 
ACK/NAK. 
force
: The IP header compression negotiation in IPCP happens normally. The local side requests the VJ 
compression option in its IPCP configure request. If the peer side requests VJ compression in its IPCP 
request, the local side will ACK/NAK the option. 
vj compress-slot-id [ both | none | receive | transmit ]
: Configures the direction in 
which VJ slotid compression should be negotiated. 
 
both
 - If the client proposes VJ slotid compression, accept it and propose slotid compression for the 
downlink and uplink. 
 
none
 - If the client proposes VJ slotid compression, NAK the offer, do not propose slotid compression 
for the downlink. 
 
receive
 - (Default) If the client proposes VJ slotid compression in the uplink direction accept the 
configuration. 
 
transmit
 - Propose VJ slotid compression for uplink. 
ipv4 { disable | enable | passive }
 
Default: enable 
Controls IPCP negotiation during PPP negotiation. 
disable
: The PDSN does not negotiate IPCP with the mobile. 
enable
: The PDSN negotiates IPCP with the mobile. 
passive
: The PDSN initiates IPCP only when the mobile sends an IPCP request. 
ipv6 { disable | enable | passive }
 
Default: enable 
Controls IPv6CP negotiation during PPP negotiation. 
disable
: The PDSN does not negotiate IPCP with the mobile.