Cisco Cisco ASR 5000
ACS Ruledef Configuration Mode Commands
▀ ip src-address
▄ Command Line Interface Reference, StarOS Release 18
970
ip src-address
This command allows you to define rule expressions to match the source IP address field within IP headers.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] ip src-address { operator { ipv4/ipv6_address | ipv4/ipv6_address/mask | address-
group ipv6_address } | { !range | range } host-pool host_pool_name }
group ipv6_address } | { !range | range } host-pool host_pool_name }
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
operator
: Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
ipv4/ipv6_address
Specifies IP address of the source node for incoming traffic.
ipv4/ipv6_address
must be an IP address in
IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
ipv4/ipv6_address/mask
Specifies the IP address of the source node for incoming traffic with subnet mask bit.
ipv4/ipv6_address/mask
must be an IP address in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal notation with subnet mask bit. The mask bit is a numeric value which corresponds to the number
of bits in the subnet mask.
of bits in the subnet mask.
address-group ipv6_address
Important:
The
address-group
keyword can be configured only after the
=
operator. The wildcard support has
not been provided for IPv4 addresses.