Cisco Cisco ASR 5000
CSCF Service Configuration Mode Commands
access-type ▀
Command Line Interface Reference, StarOS Release 18 ▄
3293
ieee-80216e
: Wireless MAN Access Type
ieee-8023
: Ethernet Access Type
ieee-8023a
: Ethernet Access Type
ieee-8023ab
: Ethernet Access Type
ieee-8023ae
: Ethernet Access Type
ieee-8023ak
: Ethernet Access Type
ieee-8023an
: Ethernet Access Type
ieee-8023aq
: Ethernet Access Type
ieee-8023e
: Ethernet Access Type
ieee-8023i
: Ethernet Access Type
ieee-8023j
: Ethernet Access Type
ieee-8023u
: Ethernet Access Type
ieee-8023y
: Ethernet Access Type
ieee-8023z
: Ethernet Access Type
radsl
: FixedLine Access Type
sdsl
: FixedLine Access Type
vdsl
: FixedLine Access Type
access-profile
{
default | name
access_profile_name
}
Associates an access type with a CSCF access profile. Different access types can refer to the same access
profile.
profile.
ue-ip-address-range name
ue_ip_name
{
address
ip_address_mask
|
range
start_ip_address end_ip_address
}
Configures UE IP address/range for a specific access type.
ue_ip_name
must be from 1 to 79 alpha and/or numeric characters.
address
ip_address_mask
: Specifies a combined IP address subnet mask bits to indicate what IP
addresses the specific access-type applies to.
ip_address_mask
must be specified using the form “IP
Address/Mask Bits” where the IP address must be expressed in dotted decimal notation for IPv4 or colon
notation for IPv6, and the mask bits are a numeric value, which is the number of bits in the subnet mask.
notation for IPv6, and the mask bits are a numeric value, which is the number of bits in the subnet mask.
range
start_ip_address end_ip_address
: Configure UE IP range for specific access-type.
start_ip_address
specifies the beginning of the range of addresses.
end_ip_address
specifies the end of the range of addresses.
ip_address
must be expressed in dotted decimal notation for IPv4 or colon notation for IPv6.
Usage
Use this command to associated the access types for a specified CSCF access profile or UE IP address/range
name.
name.
Important:
Use the
sip-header
command to enable SIP P-Access-Network-Info (PANI) header insertion.
CSCF Proxy-CSCF Configuration Mode commands are defined in the CSCF Proxy-CSCF Configuration Mode
Commands chapter in this guide.
Commands chapter in this guide.
Example
The following command identifies the access type adsl and assigns it to access profile
ap1
:
access-type adsl access-profile name ap1