Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE Maintenance Manual
LAN
IPv4 Setting
Cisco WAP131 and WAP351 Administration Guide
69
4
•
LAN1 - LAN5—Each port should have at most one untagged VLAN. The
options are:
options are:
-
Untagged—The port is a member of the VLAN. A packet of the VLAN
sent out from the port will be untagged. A untagged packet received by
the port will be classified to the VLAN (tagged).
sent out from the port will be untagged. A untagged packet received by
the port will be classified to the VLAN (tagged).
-
Tagged—The port is a member of the VLAN. A packet of the VLAN sent
out from the port will be tagged with the VLAN header.
out from the port will be tagged with the VLAN header.
-
Excluded—The port does not belong to the VLAN.
NOTE
The VLAN ID 1 cannot be deleted. If a port (wired or wireless) related to the VLAN
has been deleted, the WAP device will set its VLAN ID to 1 automatically.
has been deleted, the WAP device will set its VLAN ID to 1 automatically.
NOTE
After new settings are saved, the corresponding processes may be stopped and
restarted. When this condition happens, the WAP device may lose connectivity. We
recommend that you change the WAP device settings when a loss of connectivity
will least affect your wireless clients.
restarted. When this condition happens, the WAP device may lose connectivity. We
recommend that you change the WAP device settings when a loss of connectivity
will least affect your wireless clients.
IPv4 Setting
Use the IPv4 Setting page to configure the static or dynamic IPv4 address
assignment.
assignment.
To configure the IPv4 address settings:
STEP 1
Select LAN > IPv4 Setting.
STEP 2
Configure these IPv4 settings:
•
Connection Type—By default, the DHCP client on the WAP device
automatically broadcasts the requests for network information. If you want to
use a static IP address, you must disable the DHCP client and manually
configure the IP address and other network information.
automatically broadcasts the requests for network information. If you want to
use a static IP address, you must disable the DHCP client and manually
configure the IP address and other network information.
Choose one of these options:
-
DHCP—The WAP device acquires its IP address from a DHCP server on
the LAN.
the LAN.
-
Static IP—Manually configure the IPv4 address. The IPv4 address
should be in a form similar to xxx.xxx.xxx.xxx (192.0.2.10).
should be in a form similar to xxx.xxx.xxx.xxx (192.0.2.10).