Cisco Cisco Prime Service Catalog 10.0 Installation Guide
1-36
Cisco Prime Service Catalog Installation Guide
OL-31035-01
Chapter 1 Installation and Configuration Guide
Preinstallation Configuration for WebSphere
Configuring the DISPLAY Property (for UNIX or Linux Only)
Perform the following steps to enable the display of KPI charts on the Service Catalog UI. As stated in
the prerequisites section, if your Application Server machine is running a UNIX or Linux operating
system, you must have either X-Window Server or Xvfp (virtual framebuffer X server) installed and
running on your machine, so that WebSphere can communicate with X-Windows Server or Xvfb to
display the KPI charts.
the prerequisites section, if your Application Server machine is running a UNIX or Linux operating
system, you must have either X-Window Server or Xvfp (virtual framebuffer X server) installed and
running on your machine, so that WebSphere can communicate with X-Windows Server or Xvfb to
display the KPI charts.
To configure the DISPLAY property:
Step 1
Click the newly created WebSphere Server (that is, server1), and open the Configuration tab.
Step 2
Under the Server Infrastructure section in the right pane, choose Java and Process Management, and
click Process Definition.
click Process Definition.
Step 3
Under the Additional Properties section in the right pane, click Environment Entries.
Step 4
Click New.
Step 5
Enter the following values:
•
Name = DISPLAY
•
Value = localhost:0.0
Step 6
Click OK.
Step 7
Click Save directly to the master configuration.
Getting Port Numbers
Step 1
Click the newly created WebSphere Server (that is, server1), and open the Configuration tab.
Step 2
Under the Communication section in the right pane, choose Ports. A table that shows the Port Name and
Number appears.
Number appears.
Step 3
Write down the port number for the following Port Names. You will need this information when
completing the worksheet at the end of this section.
completing the worksheet at the end of this section.
•
BOOTSTRAP_ADDRESS =?
•
WC_defaulthost =?
If you need to modify these port numbers:
a.
To the right of the Ports table, click Details.
b.
Click the link for either BOOTSTRAP_ADDRESS or WC_defaulthost to open its General
Properties panel.
Properties panel.
c.
Modify the value in the Port field.
d.
Click OK.
e.
Click Save directly to the master configuration.