Cisco Cisco Prime IP Express 8.3 Technical References
Cisco Prime
IP Express CLI Reference Guide
Network Registrar CLI Introduction
About the nrcmd Program
The nrcmd command line interface (CLI) enables you to configure and manage your DNS, DHCP, and TFTP servers. This
section describes how to use the nrcmd CLI. It specifically describes:
section describes how to use the nrcmd CLI. It specifically describes:
Invoking the command in batch and interactive modes
Command organization and syntax
Special keyboard navigation characters
Invoking the nrcmd Command
You can invoke the nrcmd command in batch mode and run scripts that use the commands; or you can invoke the nrcmd
command in interactive mode and enter commands at the nrcmd command prompt. By default, the nrcmd command is located
in C:\Program Files\Cisco Prime IP Express\Local\bin on Windows and in /opt/nwreg2/local/usrbin on Linux.
command in interactive mode and enter commands at the nrcmd command prompt. By default, the nrcmd command is located
in C:\Program Files\Cisco Prime IP Express\Local\bin on Windows and in /opt/nwreg2/local/usrbin on Linux.
Note: On Windows, if you want to run the nrcmd program from outside the installed path, you must set the CNR_HOME
environment variable.
environment variable.
On Windows, you can invoke the nrcmd command window from the Start menu:
Start
> Programs > IP Express 8.3 > IP Express 8.3 CLI
This method prompts for your user name and password. On Linux (as well as Windows alternatively), invoke the command from
the command prompt using this syntax:
the command prompt using this syntax: