Cisco Cisco Prime Network Registrar 8.1 Technical References

 Cisco Prime

The nrcmd command line interface (CLI) enables you to configure and manage your DNS, DHCP, and TFTP servers.

 This section describes how to use the nrcmd CLI. It specifically describes:

Invoking the command in batch and interactive modes

Command organization and syntax

Special keyboard navigation characters

You can invoke the nrcmd command in batch mode and run scripts that use the commands; or you can invoke the

 nrcmd command in interactive mode and enter commands at the nrcmd command prompt. By default, the nrcmd

 command is located in C:\Program Files\Network Registrar\Local\bin on Windows and in /opt/nwreg2/local/usrbin on

 Solaris and Linux.

Note: On Windows, if you want to run the nrcmd program from outside the installed path, you must set the

 CNR_HOME environment variable.

On Windows, you can invoke the nrcmd command window from the Start menu:

 

> Programs > Network Registrar 8.1.3.4 > Network Registrar 8.1.3.4 CLI

This method prompts for your user name and password. On Solaris and Linux (as well as Windows alternatively),

 invoke the command from the command prompt using this syntax:

 

[general-options] [command] [options]

 

 

 describes the general options when invoking from the command prompt. 

Table 1-1 General Options to nrcmd Command