Cisco Cisco Access Registrar Jumpstart 5.1 Installation Guide

Determine any proxy values necessary for the virtual appliance to access the Internet.

Determine the server details for the Cisco Access Registrar Jumpstart that you need to know based 
on the IP configuration of:

DNS server details in case of static IP configuration

DHCP server details in case of dynamic IP configuration.

Configuring Cisco Access Registrar Jumpstart requires you to do the following configuration steps to 
connect it to the network:

To configure the Cisco Access Registrar Jumpstart:

Configure the UCS CIMC Network Connection. To configure this, follow the steps in the Connecting 
and Powering On (Standalone Mode) chapter of the enclosed Cisco US C200 and C210 Servers Quick 
Start Guide or you can see the document available online at 

You have to configure NIC Redundancy as None in the Connecting and Powering On (Standalone Mode) 
procedure.

The default username is admin and default password is password. While configuring the CIMC console, 
you should change the password.

The CIMC gives you considerable insight into the hardware as well as support for a virtual KVM console 
allowing remote management of the ESXi layer. For details on CIMC, see the Cisco UCS C-Series 
Servers Integrated Management Controller GUI Configuration Guide available at 

.