Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP) Technical References

The node-level default settings for the ETSI shelf assembly. Cisco provides the following types of 
user-configurable defaults for each node:

The node default settings described in this section are supported on the Cisco ONS 15454, 
Cisco ONS 15454 M6, Cisco ONS 15454 M2, Cisco NCS 2002, and NCS 2006 platforms, unless noted 
otherwise. 

Circuit settings—Set the administrative state, subnetwork connection protection (SNCP) circuit 
threshold levels for signal degradation and failure, SNCP reversion time, and whether SNCP circuits 
are revertive by default.

General settings—Set general node management defaults, including whether to use Daylight 
Savings Time (DST), the IP address of the NTP/SNTP server to be used, the time zone where the 
node is located, the SD path BER value, whether automatic autonomous TL1 reporting of PM data 
is enabled for cross-connect paths on the node, whether or not to allow ports to be disabled when 
they are providing services (when the default is set to FALSE users must remove or disable the 
services first, then put the ports out of service), and the defaults description.

Link Management Protocol settings—Set link management protocol data link type, traffic 
engineering link, and general settings.

Power Monitor settings—Set default voltage thresholds for the node.

Cisco ONS 15454 M6

Cisco ONS 15454 M12

Cisco ONS 15454 M15

NCS2002-F-SDH

NCS2002-L-SDH

NCS2006-F-SDH

NCS2006-L-SDH

NCS2015-F-SDH

NCS2015-L-SDH