Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP) Technical References
5
OL-30833-01
Network Element Defaults Description
ANSI Node Default Settings
Cisco provides the following types of user-configurable defaults for each node:
Note
The node default settings described in this section are supported on the Cisco ONS 15454,
Cisco ONS 15454 M6, Cisco ONS 15454 M2, Cisco NCS 2002, and NCS 2006 platforms unless noted
otherwise.
Cisco ONS 15454 M6, Cisco ONS 15454 M2, Cisco NCS 2002, and NCS 2006 platforms unless noted
otherwise.
•
Circuit settings—Set the administrative state and path protection circuit defaults, and whether to
have circuits send a payload defect indication condition (PDIP).
have circuits send a payload defect indication condition (PDIP).
•
General settings—Set general node management defaults, including whether to use Daylight
Savings Time (DST), whether to insert Alarm Indication Signal VT (AIS-V) in each VT when the
carrying STS crosses the signal degrade (SD) path bit error rate (BER) threshold, the IP address of
the Network Time Protocol/Simple Network Time Protocol (NTP/SNTP) server to be used, the time
zone where the node is located, the SD path BER value, the defaults description, whether to raise a
condition on an empty card slot, whether automatic autonomous Transaction Language One (TL1)
reporting of PM data is enabled for cross-connect paths on the node, whether or not to allow ports
to be disabled when they are providing services (when the default is set to FALSE users must remove
or disable the services first, then put the ports out of service), and whether to report loopback
conditions on Out-of-Service, Maintenance (OOS-MT) state ports.
Savings Time (DST), whether to insert Alarm Indication Signal VT (AIS-V) in each VT when the
carrying STS crosses the signal degrade (SD) path bit error rate (BER) threshold, the IP address of
the Network Time Protocol/Simple Network Time Protocol (NTP/SNTP) server to be used, the time
zone where the node is located, the SD path BER value, the defaults description, whether to raise a
condition on an empty card slot, whether automatic autonomous Transaction Language One (TL1)
reporting of PM data is enabled for cross-connect paths on the node, whether or not to allow ports
to be disabled when they are providing services (when the default is set to FALSE users must remove
or disable the services first, then put the ports out of service), and whether to report loopback
conditions on Out-of-Service, Maintenance (OOS-MT) state ports.
•
Link Management Protocol settings—Set link management protocol data link type, traffic
engineering link, and general settings.
engineering link, and general settings.
•
Power Monitor settings—Set default voltage thresholds for the node.
•
Network settings—Set whether to prevent display of node IP addresses in CTC (applicable for all
users except Superusers); default gateway node type; whether to raise an alarm when the backplane
LAN cable is disconnected; and whether to display the IP address in the LCD in an editable mode
(in which you can change the IP address directly from LCD screen), to display the IP address on the
LCD as read-only, or to suppress display of the IP on the LCD entirely.
users except Superusers); default gateway node type; whether to raise an alarm when the backplane
LAN cable is disconnected; and whether to display the IP address in the LCD in an editable mode
(in which you can change the IP address directly from LCD screen), to display the IP address on the
LCD as read-only, or to suppress display of the IP on the LCD entirely.
NCS2002-F-SONET
NCS2002-L-SONET
NCS2006-F-SONET
NCS2006-L-SONET
NCS2015-F-SONET
NCS2015-L-SONET
Table 1
NE Defaults for ANSI Cards
Platforms
Links