Cisco Cisco Broadband Access Center for Cable 4.1
C-13
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
System Commands
Syntax Description
When entering the password command, you must use this syntax:
password <password>
Where:
•
<password>—identifies the new DPE password
Examples
This are examples of how to use the password command:
Example 1
dpe# password
New password:
Retype new password:
Password changed successfully.
Results:
These results occur when the password is changed successfully.
Example 2
dpe# password
New password:
Retype new password:
Sorry, passwords do not match.
Results:
These results occur when the password is not entered consistently.
Example 3
dpe# password cisco
Password changed successfully.
Results:
These results occur when the password is changed (using an approach easier for scripting).
poweroff
Usage Guidelines
This command turns the DPE power off. It removes all current users from the system and shuts the DPE
down cleanly. Prior to executing this command, you should verify that there has been no hard drive
activity for approximately 30 seconds.
down cleanly. Prior to executing this command, you should verify that there has been no hard drive
activity for approximately 30 seconds.
Caution
Using the power switch on the device can potentially cause partial corruption of the DPE cache. This
could result in the DPE needing more time to rebuild its cache the next time it is powered up.
could result in the DPE needing more time to rebuild its cache the next time it is powered up.
Examples
This is an example, as shown from a Telnet session, of how to use the poweroff command:
dpe# poweroff