Cisco Cisco Broadband Access Center for Cable 4.1

When entering the command, you must use this syntax:

dpe# no packetcable snmp key-material

%OK (Requires DPE restart "> dpe reload")

This command enables PacketCable services. To enable PacketCable, you need to:

Have at least one interface configured with an FQDN and have provisioning enabled.

Have the KDC service key set. See the 

 for additional information.

This is an example of how to use the packetcable enable command:

dpe# packetcable enable

%OK (Requires DPE restart "> dpe reload")

This command enables encryption of MTA configuration files.

This is an example of how to use the packetcable registration encryption command:

dpe# packetcable registration encryption

%OK

This command is used to generate and set a security key used for communication between KDC and 
DPE.

When entering the packetcable registration kdc-service-key command, you must use this syntax:

dpe# packetcable registration kdc-service-key <password>

%OK (Requires DPE restart "> dpe reload")

Where the <password> is any password, 6 to 20 characters in length, that you create.

The password that you enter for this command must match the password that is entered into the 
keygen tool when configuring the KDC. See the 

 

for additional information.