Cisco Cisco Broadband Access Center for Cable 5.0

Run the configuration file utility using this command:

Where:

unprov.tmpl—identifies the existing template file being parsed into a binary file

unprov.cm—specifies the output filename to be used

After running the utility, results similar to these should appear:

You use the runCfgUtil.sh command to view a local binary file.

You must use this syntax when using the unCfgUtil.sh command to view a local binary file:

runCfgUtil.sh -d -l <file>

Where:

-d—specifies that the command is going to decode a binary input file for viewing

-l—identifies that the input file is located on the local file system

<file>—identifies the existing binary input file to be viewed

To view a binary file that is on the local file system:

Change directory to /opt/CSCObpr/rdu/samples/packet_cable. 

Select a binary file to view.

Run the configuration file utility using this command:

Where:

unprov_packet_cable.bin—identifies the existing binary input file to be viewed

After running the utility, results similar to these should appear:

# /opt/CSCObpr/rdu/bin/runCfgUtil.sh -l unprov.tmpl -o unprov.cm

Broadband Provisioning Registrar Configuration Utility

Version: 2.5.1.5

0 error(s), 0 warning(s) detected. Parsing of unprov.tmpl was successful.

The file unprov.tmpl was parsed successfully in 595 ms.

The parser initialization time was 262 ms.

The parser parse time was 333 ms.