Cisco Cisco Broadband Access Center for Cable 5.0
C-41
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
Log System Management Commands
no debug dpe messaging
Usage Guidelines
This command disables the debugging of DPE messaging.
Examples
This command requires no special syntax, and you enter it as shown in this example:
dpe# no debug dpe messaging
%OK
no debug dpe tftp
Usage Guidelines
This command disables the debugging of TFTP messages.
Examples
This command requires no special syntax, and you enter it as shown in this example:
dpe# no debug dpe tftp
%OK
no syslog log-server
Usage Guidelines
This command clears the settings assigned to the syslog server. When the syslog mode is set to either
both or remote, clearing the syslog log server results in the log mode being automatically set back to
local until a new log server is configured.
both or remote, clearing the syslog log server results in the log mode being automatically set back to
local until a new log server is configured.
Examples
This is an example of how to use the no syslog log-server command:
dpe# no syslog log-server
%OK (Requires appliance restart "> reload")
show log
Usage Guidelines
This command shows all recent log entries for the DPE. These logs contain general DPE process
information, including logging all system errors or severe problems. Check this log, when the system is
experiencing difficulties. If the log contains insufficient information, enable the debug logging function
and experiment with the different categories related to the problem.
information, including logging all system errors or severe problems. Check this log, when the system is
experiencing difficulties. If the log contains insufficient information, enable the debug logging function
and experiment with the different categories related to the problem.
Syntax Description
When entering the show log command, you must use this syntax:
show log