Cisco Cisco Broadband Access Center for Cable 5.0

Where:

<1-9999>—identifies the number of lines from the log file that you want to see.

This is an example of how to use the show packetcable registration log last command:

dpe# show packetcable registration log last 1 

INFO [MtaListener] 2002-09-16 14:57:48,901 (Sequence.java:115) - Looking for 

cryptix.asn1.lang.TaggedType

This command displays the recent PacketCable registration service log file, and all new log messages, 
until the command is interrupted.

This is an example of how to use the show packetcable registration log run command:

dpe # show packetcable registration log run

% Press <enter> to stop.

Error [SS_MSG] 2003-03-18 14:35:44,000 - SNMP Service Tracing Set To 800

% Stopped.

This command shows recent log entries for the PacketCable SNMP provisioning service, which includes 
information about the general PacketCable SNMP provisioning service and the logging any MTA 
provisioning errors or severe problems.

This is an example of how to use the show packetcable registration log command:

dpe# show packetcable snmp log

Error [SS_MSG] 2003-03-18 14:30:44,000 - SNMP Service Tracing Set To 400 

...

The output presented in this example is trimmed.

This command displays a specified number of lines from the PacketCable SNMP log file. 

When using this command you must use this syntax:

show packetcable snmp log last <1..9999>