Cisco Cisco Prime LAN Management Solution 4.2 Release Notes
23
Release Notes for Cisco Prime LAN Management Solution 4.2.4
OL-25950-04
Installing Cisco Prime LAN Management Solution 4.2.4
Installing Cisco Prime LAN Management Solution 4.2.4
This section describes the procedure to install Cisco Prime LMS 4.2.4 on Solaris, Soft Appliance, and
Windows systems.
Windows systems.
The LMS 4.2.4 installation program takes approximately 50 minutes to complete on Windows, Soft
Appliance and Solaris, on a single server with the recommended hardware requirements.
Appliance and Solaris, on a single server with the recommended hardware requirements.
This can take more than two hours if you perform network management integration while installing.
•
If Virus Check is enabled in your system, then installation of LMS 4.2.4 will take a longer time.
•
If HP Openview or Netview is running on your system, installation will take a longer time. Stop
these services to do a faster installation.
these services to do a faster installation.
This section contains:
•
•
•
•
•
•
Prerequisites for Installing Cisco Prime LMS 4.2.4 Software
Cisco Prime LMS 4.2.4 installation must be performed in the following order on LMS 4.2:
•
LMS 4.2 -> LMS 4.2.2 -> LMS 4.2.4
•
LMS 4.2 -> LMS 4.2.2 -> LMS 4.2.3 -> LMS 4.2.4
•
LMS 4.2 -> LMS 4.2.1 -> LMS 4.2.2 -> LMS 4.2.3 -> LMS 4.2.4. For more details, see
in Installing and Migrating to Cisco Prime LAN Management Solution 4.2.
Installing LMS 4.2.4 on Solaris
To install LMS 4.2.4 on a Solaris system:
Step 1
Navigate to the location where you have downloaded the lms4_2_4_sol_k9.zip file in your system.
Note
We recommend that you run the installation from a local hard drive to avoid errors that may result from
the network being slow or busy.
the network being slow or busy.
Step 2
Copy the downloaded software image to a directory having a minimum of 10 GB free space.
Step 3
Unzip the lms4_2_4_sol_k9.zip file.
The contents of the zip file are extracted under the lms4_2_4_sol_k9 directory.
Step 4
Navigate to the lms4_2_4_sol_k9 folder.
Step 5
Run the installation setup script by entering:
# sh setup.sh