Cisco CiscoWork QoS Policy Manager 4.1.2 User Guide
B-73
User Guide for QoS Policy Manager 3.0
78-12542-01
Appendix B Configure Tab Reference
Policy Groups
Policy Wizard: Rule Setting Page
Use this page to define conditions for a filter rule. A flow must match all
conditions in a rule to satisfy the filter. The conditions that you can defined
depend on the device constraints defined for the policy group.
conditions in a rule to satisfy the filter. The conditions that you can defined
depend on the device constraints defined for the policy group.
Table B-52 Policy Wizard Rule Setting Page
Field Description
Does not match check box
Select this check box if the flow should not match all the specified
conditions in the rule.
conditions in the rule.
Deny check box
Select this check box to deny traffic that matches the conditions in
the rule.
the rule.
Application
Application that produces the traffic, identified by Network-based
Application Recognition (NBAR). Click Edit to edit the NBAR
properties used to define the filter condition. The Application dialog
box opens. See
Application Recognition (NBAR). Click Edit to edit the NBAR
properties used to define the filter condition. The Application dialog
box opens. See
for details.
When you define a condition using NBAR, the Protocol condition
is disabled.
is disabled.
Protocol
The traffic protocol. Click Edit to edit the protocol parameters. The
Protocol dialog box opens. See
Protocol dialog box opens. See
for
details.
When you define a Protocol condition, the NBAR condition is
disabled.
disabled.
Source IP
The source address of the packet. Click Edit to edit the source IP
parameters. The Source IP dialog box opens. See
parameters. The Source IP dialog box opens. See
for details.
Destination IP
The destination address of the packet. Click Edit to edit the
destination IP parameters. The Destination IP dialog box opens. See
destination IP parameters. The Destination IP dialog box opens. See
for details.
Service
The IP precedence or DSCP value of the packets. Click Edit to edit
the service parameters. The Service dialog box opens. See
the service parameters. The Service dialog box opens. See
for details.
CoS
The CoS value of the packets. Click Edit to edit the CoS
parameters. The CoS dialog box opens. See
parameters. The CoS dialog box opens. See
for details.