Cisco Cisco Prime Optical 9.6 Technical References
45
Cisco Prime Optical 9.6.3 ML Provisioning Methodology
OL-28046-01
Enabling or Disabling Rapid Spanning Tree Protocol
Enabling or Disabling Rapid Spanning Tree Protocol
You can enable Rapid Spanning Tree Protocol (RSTP) on UNI dot1Q, UNI Untagged, and NNI dot1Q
ports by selecting the RSTP for the selected drop port and then checking the RSTP Enable check box
(see
ports by selecting the RSTP for the selected drop port and then checking the RSTP Enable check box
(see
). To disable RSTP, select the RSTP for the selected drop port and uncheck the RSTP
Enable check box.
Note
RSTP can be enabled only on a drop where UNI/NNI dot1Q is selected and only on a subinterface (that
is, UNI dot1Q drop) where no other QinQ drops were created for the same interface.
is, UNI dot1Q drop) where no other QinQ drops were created for the same interface.
Figure 23
Create Layer 2 Service Wizard—RSTP Enable
Click Next to configure QoS parameters as required (see
rttMonJitterStatsNumOfOW
The number of one-way times that were measured successfully.
rttMonJitterStatsOWMinSDNew
The minimum number of all one-way times from the source to the destination.
Replaces deprecated rttMonJitterStatsOWMinSD.
Replaces deprecated rttMonJitterStatsOWMinSD.
Table 5
PM-Related Data for Jitter (continued)
Prime Optical Name
Field Supported